Holding the matrix by the tab in Triodent Pin-Tweezers, simply bend the tab towards you (mesially) to create a “contra-angle” handle. Then move the V3 Tab-Matrix apically into the embrasure. Try to avoid trapping gingival tissue between the matrix and the gingival margin of the cavity.

While burnishing the V3 Tab-Matrix, bend the tab over and fold it out of the way.

Firstly, peel the matrix away from the composite as far as possible on both sides using a suitable instrument. Gently rocking the matrix back and forth should then make it easy to remove. Use Triodent Pin-Tweezers to grab the hole on the wings of the V3 Tab-Matrix and wiggle the matrix out. Grabbing the tab may rip it off but the lateral holes work better. You can also try flossing (waxed floss) between the matrix and the restoration. Take care not to lacerate the gingival papillae by excessively rocking the matrix.

If you prefer to place the V3 Tab-Matrix before the Wave-Wedge, use a finger to trap the matrix tab against the neighboring tooth while inserting the wedge. This will prevent the matrix sliding out of the embrasure.

Yes. In fact this is usually the best way to do it. Place the Wave-Wedge first, BEFORE cavity prep. This pre-wedging prevents bleeding, separates the teeth slightly and positions the wedge more apically, thereby allowing the contact point to be lower. The wedge will also depress the interproximal gingivae and rubber dam and protect both from the high-speed bur. Most of the time you will then be able to slide the V3 Tab-Matrix into place without removing the wedge.

To ensure complete curing of the composite, fold the wings of the V3 Tab-Matrix back (after removing the ring and wedges) and cure from the buccal and lingual sides.

Positioned correctly, the rolled marginal ridge on the V3 Tab-Matrix will save you a lot of time in finishing because it closely replicates the natural anatomy of the tooth. To maximize the benefits of the ridge, take care to position the band exactly. If it won't go into the ideal position, slide the edge out while trapping the tab of the matrix against the neighboring tooth, then push the wedge back in. This method also eliminates the possibility of a gingival tag protruding into the cavity box.

Triodent Pin-Tweezers have a gold tip on one side, which indicates the side with the pin. Insert the matrix with the gold tip facing away from the occlusal surface. Then when you release the tweezers, the pin will be well away from the tab.

The easy way around this is to place the yellow V3 Ring on the tooth, trapping the matrix band in place, then bend the protruding ends of the matrix backwards to make room for the opposite matrix band.